Intermec PF2i Bedienungsanleitung PDF herunterladen (Seite 63)

Chapter 2 — Connecting the Printer

PF2i and PF4i Mid-Range Printer User’s Manual 49

To set up the printer for 802.11 communications using HyperTerminal

1 Connect one end of the serial cable to your printer, and connect

the other end to your PC.

2 On your PC, open HyperTerminal and set these serial port

parameters:

3 From the host PC, check the wireless settings. For help, see

“Manually Configuring IP Settings” on page 46.

If you are running IPL, send this command to the printer:

If you are running Fingerprint, send these commands to the

printer:

setup write "wlan","uart1:"

setup write "8021x","uart1:"

4 Configure your printer to use the correct SSID and authentication

modes. For help, see the next section, “Configuring 802.11

Wireless Security Using Fingerprint” or “Configuring 802.11

Wireless Security Using IPL” on page 53.

5 If you are using certificates for validation, Intermec recommends

testing first without the certificate. Only after performing this test

should you transfer the certificate to the printer. The printer can

accept PEM (.pem), DER (.der), and PKCS #12 (.p12 or .pfx)

certificates.

6 Verify that the printer is connected to the access point and make

sure it has an IP address allocated to it.

Use the following sections to set most of your wireless

communication settings. For more information, see the Intermec

Fingerprint Command Reference Manual or the IPL Command

Reference Manual.

Parameter Default Setting

Baud rate 9600

Data bits 8

Parity None

Stop bits 1

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 193 194

Keine Kommentare

Intermec PF2i Bedienungsanleitung Seite 63