Intermec PF2i Bedienungsanleitung PDF herunterladen (Seite 60)

Chapter 2 — Connecting the Printer

46 PF2i and PF4i Mid-Range Printer User’s Manual

If your network does not automatically assign an IP address, or the

Intermec Ready-to-Work indicator is blinking to indicate a network

error, you can use PrintSet (available on the PrinterCompanion CD or

as a download from www.intermec.com) to correct the network

settings.

Manually Configuring IP Settings

You can configure the IP settings of your printer by sending

Fingerprint or IPL commands through a serial connection. After you

configure the IP settings, you can disconnect the printer from your PC

and communicate with the printer using Ethernet communications.

To configure the IP settings serially using Fingerprint

1 Connect the printer to your PC using a serial cable. For help, see

“Connecting the Printer to a PC Through the Serial Port” on

page 42.

2 Send the following commands to permanently assign the IP

address, subnet mask, default router, and name server:

setup "network,IP selection,manual"

setup "network,IP address,xxx.xxx.xxx.xxx"

setup "network,netmask,xxx.xxx.xxx.xxx"

setup "network,default router,xxx.xxx.xxx.xxx"

setup "network,nameserver,xxx.xxx.xxx.xxx"

where xxx is a number from 0 to 255.

3 Disconnect the printer from the PC.

4 On your PC, enter the IP address of the printer in the address field

of your web browser (for example http://10.200.27.94) and press

Enter.

The home page of the printer appears.

To configure the IP settings serially using IPL

1 Connect the printer to your PC using a serial cable. For help, see

“Connecting the Printer to a PC Through the Serial Port” on

page 42.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 193 194

Keine Kommentare

Intermec PF2i Bedienungsanleitung Seite 60