Intermec PF2i Bedienungsanleitung PDF herunterladen (Seite 123)

Chapter 4 — Troubleshooting and Maintaining the Printer

PF2i and PF4i Mid-Range Printer User’s Manual 109

3 Lift and lower the printhead.

4 Press the Print button.

5 Make sure there is a label (not a gap or mark) at the LSS.

6 Make sure that the media is routed as close to the center section as

the guide allows.

7 Press T to enter the Setup menu, and use the keypad to go to the

LSS menu:

• If you are running Fingerprint, go to SETUP > PRINT DEFS >

LSS TEST > LSS AUTO.

• If you are running IPL, go to SETUP > TEST/SERVICE > LSS

TEST > LSS AUTO.

The screen displays the LSS AUTO menu with the cursor in the

center.

8 Check gap detection:

a Lift the printhead.

b Slowly pull out the media. When the LSS detects a gap or

detection slot, the cursor moves to the right.

LSS AUTO



Note: There is no way to adjust the LSS function; the menus

only indicate values obtained from the LSS. The test menu can

determine if the sensor unit is not physically in position, is blocked

by dust or stuck labels, or is defective in some way.

LSS AUTO



1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 193 194

Keine Kommentare

Intermec PF2i Bedienungsanleitung Seite 123