Intermec PF2i Bedienungsanleitung PDF herunterladen (Seite 113)

Chapter 4 — Troubleshooting and Maintaining the Printer

PF2i and PF4i Mid-Range Printer User’s Manual 99

Troubleshooting Printer Problems and Finding Solutions

Use this section to find possible solutions to printer problems.

Ribbon Out The printer is out of transfer ribbon. Load a new roll

of ribbon. For helps, see “Loading Ribbon” on

page 30.

Blinking 1031

Setup mode entered. Off

IP link error. No network connection. Blinking

IP configuration error. The printer is trying to

acquire an IP address from the network. Wait for the

printer to complete the task before taking any

action.

Blinking

Rebooted Off

Initializing Off

Printer crash. In most instances, when the printer

crashes, the screen is reset which causes the Intermec

Ready-to-Work indicator to turn off.

Off

Printer turned off Off

Maintenance Off

IPL Error Messages (continued)

Message Description

Ready-to-Work

Indicator Status

Error

Number

Print Quality Problems and Possible Solutions

Problem Possible Solution

The printout is weak, overall. Try these possible solutions in order:

• Make sure that your media setting is appropriate for the

type of media you are using.

• The contrast may be too low. Try increasing the contrast.

• The printhead pressure may be too low. Increase the

printhead pressure. For help, see “Adjusting the

Printhead Pressure” on page 111.

• Replace the printhead. For help, see “Replacing the

Printhead” on page 120.

The printout is weaker on one side. Adjust the pressure arm. For help, see “Adjusting the

Pressure Arm” on page 106.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 193 194

Keine Kommentare

Intermec PF2i Bedienungsanleitung Seite 113