Intermec PF8D Bedienungsanleitung PDF herunterladen (Seite 60)

Chapter 2 — Connecting the Printer

48 PF8d and PF8t Desktop Printer User’s Guide

Configuring the Printer By Sending Commands From Your PC

1 Establish a HyperTerminal connection to your PC. For help, see

“Connecting the Printer Through the Serial Port” on page 38

or “To connect your printer to the Ethernet network” on

page 44.

2 In the HyperTerminal window, type a network configuration

command and press Enter. For example, using commands you can

set these parameters:

• IP address

• Gateway

• Nameserver

For a list of network configuration commands, see the ESim for the

PC4, PF8, PD41, and PD42 Printer Programmer’s Reference

Manual.

3 In the HyperTerminal window, type UQ and press Enter. The list of

network configurations set for the printer are displayed in the

window.

Upgrading the Firmware

To upgrade the printer firmware, you can use the Config Tool to

install the firmware files. You can download the Config Tool from the

PrinterCompanion CD or Intermec web site at www.intermec.com.

To upgrade printer firmware

1 Make sure your printer is connected to your PC. For help, see

“Connecting the Printer to Your PC” on page 38.

2 Download the firmware (.ufz) files to your PC. For the latest files,

go to www.intermec.com.

3 Start the Config Tool. The Intermec Config Tool screen appears.

Note: Intermec recommends that you upgrade the printer firmware

using PrintSet. For more information, see “Configuring the Printer

Using PrintSet” on page 47.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 91 92

Keine Kommentare

Intermec PF8D Bedienungsanleitung Seite 60